Menu "Security; Main Menu "Sound - Teufel Impaq 8000 Technical Description And User Manual

Menu "Security"

Setting for the child lock for BD/DVD playback. Some
BD/DVDs are labelled for certain age groups and
cannot be played back if a corresponding setting has
been configured. Unfortunately, many BD/DVDs are
not properly protected and even personally burned
copies and video movies are not provided with this
protection.
You will need a four-digit password to change the
setting. The default is "0 0 0 0" (the number zero four
times).
" Change the password"
1. First enter the current password with the number
buttons 1...0 (22).
2. Then enter the new password twice with the num-
ber buttons 1...0 (22).
Be sure to memorise the new password! You can reset
the receiver to the default settings in an emergency
(see the "System" menu).
"Child lock"
Setting the protection level. Eight levels are availa-
ble, which correspond to the recommendations of
the MPAA (Motion Picture Association of America)
for rating movies. This system only takes effect with
American DVDs/BDs.
You will be asked for a password in order to open this
menu.
• Off – This turns protection off. All movies can be
played back without restrictions.
• CHILDREN – suitable for children.
• G – all children and general supervision.
• PG – parental supervision.
• PG-13 – parental supervision for children under 13
years of age.
• PGR – parental supervision required.
• R – restricted viewing.
• NC-17 – not permitted for persons 17 years of age
and under.
• ADULT – only for adults.

Main menu "Sound"

You can set the sound system of the Impaq 8000 in
this menu.
Menu " Dynamic range"
This function prevents high volume peaks; the 10
highest levels on CD, DVD and BD are limited. Please
keep in mind that this only works with Dolby Digital
audio tracks.
Menu " Sound"
Here you can configure the sound within two frequen-
cy ranges:
Bass low tones
Treble high tones
You can configure either tone range from "–10 dB"
(lower) to "+10 dB" (increase).
(Also see „Adjusting the sound" on page 17.)
Menu " Level"
You can increase or decrease the relative volume
from "+10 dB" to "–10 dB" for each speaker here. Se-
lect the "dB" value and change it with the navigation
buttons ▲▼ (25).
(Also see „Adjusting the channel level" on page 18.)
Menu " Test tone"
Volume adjustment with a test tone. As previously
described with "Level", you can increase or decrease
the relative volume for each speaker. In the pro-
cess, audio playback will be replaced by a test tone
(a noise) whose volume can be adjusted using the
control (5) and the Volume +/– buttons (28). The test
tone mutes as soon as you leave the sub-menu.
Menu " Lipsync"
Digital image processing in the television set requires
some time. In order to keep the image and sound
synchronous, television sets delay the sound by a
few milliseconds. To ensure that the sound of your
Impaq 8000 is also synchronous, you can configure
the audio delay for certain inputs from 0 to 200 ms
here.
(Also see „Setting the audio delay" on page 18.)
Menu "Input level"
Here you can set the relative volume from –10 dB to
+10 dB for each source in order to adjust different
levels of the internal and external sources.
Settings
• Impaq 8000 27