Setting The Audio Delay; Adjusting The Channel Level - Teufel Impaq 8000 Technical Description And User Manual

Setting the audio delay

During movie playback, sometimes the image and
audio are out of sync. You can use this function to re-
solve this bothersome effect by configuring the audio
delay for certain inputs from 0 to 200 ms.
1. Push the Lip Sync button (43). " Lipsync" will ap-
pear on the display and an input under it.
2. Select the input with the navigation buttons ◀▶
(25): HDMI 1, HDMI 2, HDMI 3, DISC, other (other
inputs).
3. With the navigation buttons ▲▼ (25), set the delay
between the picture and the audio (0 to 200 ms).
Shortly after the last button is pushed, the original
readout will appear again on the display. The new
settings have now been saved.

Adjusting the channel level

With this function, you can increase or decrease the
relative volume for each speaker from "+10 dB" to
"–10 dB".
1. Push the Level button (44). "Speaker level" will
appear on the display and a channel under it.
2. Select the desired channel with the navigation
buttons ◀▶ (25):
– Subwoofer
– Front left
– Center
– Front right
– Surr.left
– Surr.right
– Rear left
– Rear right
3. Set the relative volume (–10 dB to +10 dB) with the
navigation buttons ▲▼ (25).
Shortly after the last button is pushed, the original
readout will appear again on the display. The new
settings have now been saved.
18 • Impaq 8000
1 2
4 5
7 8
0
SEARCH
OSC
SOURCE VOLUME
TV /ARC) RADIO
44
LEVEL TONE SURROUND
43
LIP SYNC SUBTITLE REPEAT
MEMORY
3
6
9
CLEAR
25
INFO
RDS