Special Notes - Clearaudio Master Innovation Black User Manual

User manual

5. Special notes

5.1 Maintenance
• If the Master Innovation turntable is to be unused for some time, please disconnect the motor
from the main power supply.
• Every two years you can lubricate the bearing of the turntable platter with the bearing oil
provided; 1 or 2 drops will be enough.
• If any damage to the power cord should occur, please ensure that this is repaired only by
authorized personnel. Please note: A damaged power cord must be exchanged immediately.
Caution!
Please use only non-alcoholic fluids specifically intended for acrylic to clean the
Master Innovation
Otherwise damage to the material or the surface can occur. Avoid using dry cloths for cleaning due
to electrostatic charging. Suitable cleaning materials are available from Clearaudio
(www.analogshop.de) or from your local hifi dealer.
5.2 Transportation
• For any required transportation of the
turntable platter and the shaft holder. Otherwise serious damage may occur. To avoid any dust
getting into the bearing, the bearing hole should be covered.
• Please ensure that you send the
packaging. Without the original packaging, Clearaudio's warranty will not be valid.
When repackaging the turntable, please follow in reverse the steps indicated in this manual for
installation and setup (from section 1).
5.3 Service
Any required servicing of Clearaudio products should be carried out by authorized personnel only.
In the case of repairs, the
Clearaudio distributor or dealer, or directly to the Clearaudio factory:
Made in Germany
turntable.
Master Innovation
Master Innovation
Master Innovation
Clearaudio electronic GmbH
Spardorfer Str. 150
91054 Erlangen
Phone.: +49 9131 40300 100
Fax: +49 9131 40300 119
www.clearaudio.de
www.analogshop.de
info@clearaudio.de
turntable, please always remove the
turntable always and only in its original
turntable must be sent to your nearest authorized
Germany
17