Special Notes - Clearaudio Ovation User Manual

User manual

3. Special notes

3.1 Maintenance
Ovation
• The Clearaudio
Ovation
• If the turntable is a longer time not in use, please disconnect the motor from the main
supply
• Every two years you can lubricate the bearing of the turntable platter with the delivered oil.
In this case it is enough to put 1 or 2 drops of the oil into bearing.
• Please take special caution to any damages of the power cord. Any damages should be repaired
only by authorized personal. A damaged power cord must be exchanged immediately!
• For a new turntable that has recently been shipped, has been un-used for a significant period of
time, or has recently been shipped or transported to a different environment, it is advisable to
double-check and re-tighten all chassis and armboard bolts on the underside of the turntable.
Due to the various materials used in the turntable plinth that can expand or contract at different
rates as a result of temperature and humidity changes, these bolts may become loose and need
to be re-tightened.
Caution!
Please use only non alcoholic fluids and only fluids specially used for acrylic, to clean the
Ovation
turntable.
Otherwise damage on the material or the surface can occur!
Don't use try cloths for cleaning because of the electrostatic charging. Suitable cleaning
fluids will be available at Clearaudio (www.analogshop.de) or your Hifi dealer.
3.2 Transportation
Ovation
Send / ship the
Only in the original packing Clearaudio can provide the warranty. If you repackage the turntable,
please make all steps inverted like at installation and setup (chapter 2).
• If any transportation of the
turntable platter and the shaft holder. Otherwise serious damage can occur!
• To avoid any dust coming into the bearing, the bearing hole needs to be covered as well.
3.3 Service
In case of any necessary, service for all Clearaudio products should be done by authorized
personal only. In case of any repair, the Clearaudio
nearest authorized Clearaudio distributor, dealer or directly to the Clearaudio factory.
Made in Germany
does not require extensive maintenance.
turntable always and only in the original packing!!!
Ovation
turntable should be necessary, please always remove the
Clearaudio electronic GmbH
Spardorfer Str. 150
91054 Erlangen
Germany
Phone.: +49 9131 40300 100
Fax: +49 9131 40300 119
www.clearaudio.de
www.analogshop.de
info@clearaudio.de
Ovation
turntable needs to be send to your
13