Special Notes - Clearaudio Performance DC User Manual

User manual

3. Special notes

3.1 Maintenance
Performance DC
• If the
the main supply.
• Every two years you can lubricate the bearing of the turntable platter with the delivered oil.
In this case it is enough to put 1 or 2 drops of the oil into bearing.
• Please take special caution to any damages of the power cord. Any damages should be repaired
only by authorized personal. A damaged power cord must be exchanged immediately!
Caution!
Please use only non alcoholic fluids and only fluids specially used for acrylic, to clean the
Performance DC
turntable.
Otherwise damage on the material or the surface can occur!
Don't use try cloths for cleaning because of the electrostatic charging. Suitable cleaning
fluids will be available at Clearaudio (www.analogshop.de) or your Hifi dealer.
3.2 Transportation
Performance DC
Send / ship the
Only in the original packing Clearaudio can provide the warranty.
If you repackage the turntable, please make all steps inverted like at installation and setup (chapter
2).
• If any transportation of the
remove the turntable platter and the shaft holder. Otherwise serious damage can occur!
• To avoid any dust coming into the bearing, the bearing hole needs to be covered as well.
3.3 Service
In case of any necessary, service for all Clearaudio products should be done by authorized perso-
nal only.
In case of any repair, the Clearaudio
authorized Clearaudio distributor, dealer or directly to the Clearaudio factory.
12
turntable is a longer time not in use, please disconnect the motor from
turntable always and only in the original packing!!!
Performance DC
turntable should be necessary, please always
Performance DC
Clearaudio electronic GmbH
Spardorfer Str. 150
91054 Erlangen
Germany
Phone.: +49 9131 40300 100
Fax: +49 9131 40300 119
www.clearaudio.de
www.analogshop.de
info@clearaudio.de
turntable needs to be send to your nearest
© clearaudio electronic GmbH, 2017/11