Table of Contents
Advertisement
You can slide the mounting brackets along the fixture by loosening the slide grubscrew (1) using a 2mm
hex key (not supplied). Ensure that the grubscrew is re-tightened to lock the bracket in the desired
position.
2
3
You can reverse the orientation of the mounting brackets so that the flanges face inwards by removing the
M6 hex-head bolts (2) and washers (3). In most cases, leaving the mounting flanges on the outside is
preferable because it provides easier access to the hinge bolts for tilt adjustment.
3
Reassemble the bracket with the mounting flange and bolt (2) on the inside, ensuring that you fit the
washer (3) as shown above, between the bracket and the flange.
Fastening to the mounting surface
To mount a fixture on a suitable surface:
1.
Loosen the hinge bolts and tilt the mounting brackets to 90 degrees. This allows you easy access to
screw the brackets to the mounting surface.
2.
Fasten the mounting brackets loosely to the mounting surface using two suitable fasteners in each
bracket.
3.
Refer to 'Connecting fixtures' on page 13 and connect the fixture power + data input to the output of
the previous fixture.
4.
Adjust the position of the mounting brackets as necessary. Tighten the fasteners in the flange and the
slide lock grubscrew on each mounting bracket.
5.
Pivot the mounting brackets to the desired tilt angle and tighten the hinge bolts.
12
1
2
RUSH® CS Series User Manual
1
2
3
Advertisement
Table of Contents
