Ac Charging Unit Installation; Figure 57 Rtd Input Connections - ABB XSeriesG4 User Manual

4.12 AC Charging Unit Installation

The ac power charging unit maintains a constant voltage charge on the installed battery pack.
Materials (supplied):
The following hardware is required to mount the ac power charging unit to the flow computer.
— ac charging unit
— Coupling nipple
Additional Materials (not supplied):
— Plastic cable ties or zip ties
— ac wiring, conduit (rigid or flexible)
WARNING- Bodily injury: To maintain system certification, all wiring must comply with NEC 501 code and
applicable ABB certification drawings.
WARNING- Bodily injury: To prevent injury, only a licensed electrician should install ac power wiring to the
customer supplied primary ac power source.
4.12.1 Step-by-Step Instructions
Tools needed
-12" crescent wrench
-Flat blade screwdriver
J9
13
25
XIMV INTERFACE

Figure 57 RTD Input Connections

75
J6
J7-1 DRAIN WIRE
J7-2 WHITE WIRE
J7
J7-3 WHITE WIRE
J7-4 BLACK WIRE
J7-5 BLACK WIRE
J8
XFC G4 2103335 Rev AB