Communication Objects General - ABB ES/S 4.1.2.1 User's Product Manual

ABB i-bus KNX
3.3.2 Communication objects
General
© 2010 ABB STOTZ-KONTAKT GmbH
Commissioning
No. Function
0 In operation
In order to regularly monitor the operation of the Electronic Switch Actuator, an In operation
telegram can be sent cyclically on the bus.
The communication object is enabled if in the parameter Send communication object "In op-
eration" in the parameter window General, page 20, has been selected with the option yes.
In the parameter window General, you can parameterize if a telegram with the value 1 or 0
is sent cyclically.
Telegram value: 0/1= system operational
1 Request status values
If a telegram with the value 0 or 1 (depending on the parameterization) is received on the
communication object, for all outputs the status byte is sent as well as all other status values
or communication objects programmed with the option after request or after a change
or request.
Status manual Operation
Fault control value
Status control value
Status valve purge
Telegram value: 1/0 = Request status values
2 Enable/ block manual ope-
ration
The Manual operation, page 11, of the device is enabled or blocked via this communication
object.
Note
If this communication object is assigned to a group address, the manual
operation is blocked after each download, ETS reset or bus voltage recov-
ery.
If this communication object is not assigned with a group address, manual
operation is enabled.
If the communication object has the value 0, manual operation can be activated using this
button on the device.
Telegram value: 0 = manual operation enabled
1 = manual operation disabled (KNX mode)
Object name Data type
General 1 bit
DPT 1.002
General 1 bit
DPT 1.017
General 1 bit
DPT 1.003
Flags
C, R, T
C, R, T
C, W
41