Installing The Optional Board; Installing The Plug-In Boards - Sony MVS-6530 Installation Manual

1-4. Installing the Optional Board

The following options are available for the MVS-6520/6530/3000.
MVS-6520/6530 optional board list
Model name
MKS-6550
Format Converter Board
MKS-6570
Digital Multi Effect Board
MVS-3000 optional board list
Model name
MKS-6550
Format Converter Board

1-4-1. Installing the Plug-in Boards

c
Be sure to turn off the POWER switch before starting
installation work.
If installation work is started with the POWER switch left
on, it may cause electrical shock or damage to printed
circuit boards.
In MVS-6520/6530/3000, the slot for installing each
plug-in board is specified. Install each board in the speci-
fied slot correctly according to the indications as described
in 1 and 2 below.
1 The board name is indicated close to the left-of-center
of each plug-in board.
2 The board name is indicated on the right surface of the
inside of front panel of MVS-6520/6530/3000.
m
. Check to see that connectors of the plug-in boards are
securely inserted into the mother board (MB-1196/1196A
board) without loose contact.
If any plug-in board is inserted into the incorrect slot, it
causes a system error and the system will not work
correctly.
. After installing the plug-in board, the software must be
installed. Install the software of V8.00 or later version.
For installing the software, refer to the User's Guide of
the MVS-6520/6530/3000 system.
MVS-6520
Board configuration
Plug-in board (Front)
FC-114 board
DVP-55 board
Board configuration
Plug-in board (Front)
FC-114 board
Installation Procedure
1. Turn off the main power of this unit and disconnect the
AC power cord from the wall outlet.
2. Loosen the four screws (with drop-safe) and remove
the front panel in the direction of the arrow.
Screws
(with drop-safe)
Front panel
3. Remove the four fixing screws (B3 x 8) and remove
the Extract PWB stopper assembly.
PSW
3 x 8
Extract PWB stopper
assembly
PSW3 x 8
Screws
(with drop-safe)
1-5 (E)