Sony MVS-6530 Installation Manual page 12

3. Loosen the screws on the rear of the right and left
adapters and adjust the length of the adapter according
to the depth of the rack.
(The illustration below shows the left adapter.)
Adapter
Portion of
the rail
n
Maximum depth of adapter: 750 mm
Minimum depth of adapter: 595 mm
4. Attach the right and left adapters to the rack complete-
ly using the specified six screws.
(The illustration below shows the left adapter.)
4U
B4 x 10
1U
1-8 (E)
B4 x 6
B4 x 6
31.75
B4 x 10
31.75
Unit: mm
5. Tighten the screws (B4 x 6 : two screws each on the
right and left) for adjusting the length of the adapter
completely (the screws that were loosened in step 3).
6. Remove the front panel of the equipment.
(Refer to Section 1-4-1.)
7. Align the groove of the rack bracket at the side of the
equipment with the rail, and slide the equipment to the
rear.
n
The rack brackets are hooked on the rails as shown
below.
Rack bracket
Rail
8. Fix the rack angle in the rack using the specified
screws.
Rack angle
B5 x 12
9. Attach the front panel to this unit.
(Refer to Section 1-4-1.)
Rack bracket
Rail
B5 x 12
Rack angle
MVS-6520