Sony MVS-6530 Installation Manual page 21

LED
D302 (C-1): +12V
+12V power status indication.
Lit when +12V is supplied.
D304 (C-1): +3.3V
+3.3V power status indication.
Lit when +3.3V is supplied.
D305 (D-1): +2.5V
+2.5V power status indication.
Lit when +2.5V is supplied.
D306 (D-1): +1.8V
+1.8V power status indication.
Lit when +1.8V is supplied.
D303 (D-1): +1.2V
+1.2V power status indication.
Lit when +1.2V is supplied.
D307 (E-1): +1.0V
+1.0V power status indication.
Lit when +1.0V is supplied.
D309 (E-1): +0.9V
+0.9V power status indication.
Lit when +0.9V is supplied.
D308 (C-1): REG (+1.5V-A, +1.1V-A)
+1.5V-A and +1.1V-A power status indication.
Lit when +1.5V-A and +1.1V-A are supplied.
D310 (D-1): +1.2V-A
+1.2V_A power status indication.
Lit when +1.2V-A is supplied.
D700 (E-1): CADEC Config Status LED
If the LED stays lit, CADEC (IC006) may not operate
normally.
D1000 to D1004 (E-1): FPGA Config Status LED
Lit during each configuration of FPGA (IMPIF 4 to 1,
MIXER) and goes out when it is completed.
If the LED stays lit, FPGA being configured may not
operate normally.
MVS-6520
D2200 to D2207 (F-1): IMP1 (PP_K12) status LED
IMP1 status indication.
D2208 to D2215 (F-1): IMP2 (PP_K34) status LED
IMP2 status indication.
D2300 to D2307 (G-1): IMP3 (ME1_K12) status LED
IMP3 status indication.
D2308 to D2315 (G-1): IMP4 (ME1_K34) status LED
IMP4 status indication.
D600 (J-1): RESET status LED
Not used.
Switch
S600 (J-1): RESET switch
Not used.
Connector
CN1101 (H-1): DEBUG connector
Not used.
CN1100 (H-1): EPR2 connector
For production.
CN2400 to CN2403: TERM1-4 connector
Not used.
CN1102 to CN1105: JTAG ICE (IMP1-4) connector
Not used.
1-17 (E)