Rack Mounting - Sony MVS-6530 Installation Manual

1-5. Rack Mounting

The MVS-6520/6530/3000 is mounted in the 19-inch
standard rack. To mount the MVS-6520/6530/3000 in the
rack, use the specified rack mount kit and follow the
procedure described below.
. Specified rack mount kit : RMM-10
n
If other than the specified rack mount kit is used, the unit
may not be mounted in the 19-inch standard rack.
Parts of the RMM-10
. Rack bracket
. Right rack mount adapter
. Left rack mount adapter
. Rack bracket attaching screw (B4 x 6: 7-682-560-09) 6 pcs
. Adapter attaching screw (B4 x 10: 7-682-562-09) 6 pcs
Other required parts
To mount in the rack, the rack mount kit RMM-10 and the
following part are required.
. Screw for rack mounting (B5 x 12 : 7-682-576-04) 4 pcs
1. Precautions for rack mounting
w
. To prevent the rack from falling or moving, fix the rack on
a flat and steady floor and the like using bolts or others.
If the rack falls due to the weight of the equipment, it
may cause death or serious injury.
. Be sure to use the specified rack mount kit.
If not, injury may result and the equipment may fall due
to insufficient strength.
. After rack mounting, be sure to tighten the screws on the
rack angle and fix the unit in the rack.
If the screws on the rack angle are not tightened, the unit
may slip from the rack and fall, causing injury.
c
When mounting the unit in the rack, note the following:
. Be sure to mount in the rack with two persons or more.
. Be careful not to catch your fingers or hands in the rack
mount rail or others.
. Mount in the rack in a stable position.
n
If several units are mounted in a rack, it is recommended to
install a ventilation fan to prevent temperature rise inside
the rack.
MVS-6520
2. Rack mounting procedure
This section describes the rack mounting procedure using
the RMM-10 rack mount kit.
1. Loosen the four screws (B4 x 10) and remove the four
feet.
2 pcs
1 pc
1 pc
Feet
B4 x 10
2. Attach the rack bracket to the side of the equipment
using the specified six screws.
n
Use B4 x 6 screws.
Tighten the screws to the following torque.
Tightening torque: 120 x 10
Rack bracket
B4 x 6
Feet
B4 x 10
_2
N.m {12.2 kgf.cm}
B4 x 6
Rack bracket
1-7 (E)