Safety Warnings; Precautions Against Static Electricity - Veeder-Root TLS-450PLUS Hardware Replacement Manual

Introduction
ELECTRICITY
High voltage exists in, and is supplied to, the device. A
potential shock hazard exists.
WARNING
Heed the adjacent instructions to avoid damage to
equipment, property, environment or personal injury.
READ ALL RELATED MANUALS
Knowledge of all related procedures before you begin
work is important. Read and understand all manuals
thoroughly. If you do not understand a procedure, ask
someone who does..

Safety Warnings

OFF

Precautions Against Static Electricity

Before removing electronic components from their anti-static bags read the following static electricity precautions.
1. Before handling any components, discharge your body's static electric charge by touching a grounded
surface.
2. Do not remove parts from their anti-static bags until you are ready to install them.
3. Do not lay parts on the anti-static bags! Only the insides are anti-static.
4. When handling parts, hold them by their edges and their metal mounting brackets.
5. Avoid touching components or edge connectors that plug into slots and wear the anti-static wrist strap (Part
No. 576010-908) included in your component replacement kit.
6. Never slide parts over any surface.
7. Avoid plastic, vinyl, and Styrofoam in your work area.
WARNING
This system operates near highly combustible fuel storage tanks.
FAILURE TO COMPLY WITH THE FOLLOWING WARNINGS AND SAFETY
PRECAUTIONS COULD CAUSE DAMAGE TO PROPERTY, ENVIRONMENT,
RESULTING IN SERIOUS INJURY OR DEATH.
To ensure proper installation, operation, and continued safe use of this product:
1. Read and follow all instructions in this manual, including all safety warnings.
2. Have equipment installed by a contractor trained in its proper installation and
in compliance with all applicable codes including: the National Electrical
Codes; federal, state, and local codes; and other applicable safety codes.
3. Before working on this console, turn off, tag and lockout power to the console.
4. Substitution of components may impair intrinsic safety.
5. Do not modify or use service parts other than those provided by Veeder-Root.
TURN POWER OFF
Live power to a device creates a potential shock hazard.
Turn Off power to the device and associated accessories
OFF
when servicing the unit.
STATIC SENSITIVE COMPONENTS
Wear grounded anti-static wrist strap before handling
the printed circuit board and mounted components
2
Safety Warnings