Table of Contents
Advertisement
7
Operation
7.1
Operation Modes
When you power on the device the first thing you see is the main menu with the following
options:
⊗
MANUAL
⊗
PROFILES
⊗
WHO-PROFILES
To return to the main menu press the STOP button once or several times.
Note! Pacemaker patients are recommended to only use the MANUAL mode!
7.1.1
MANUAL
In this mode you can choose any workout time and workload.
1.
Press PLUS/MINUS until MANUAL is highlighted. Confirm your selection with
START.
2.
You now access the workout mode. Here you can change the workload by pressing
PLUS/MINUS. If you want to change the workload substantially, press and hold
PLUS/MINUS. On the TRAC you can also change the incline by pressing UP and
DOWN.
3.
top the workout by pressing the STOP button. The workout parameters (Watt, 1/min
etc.) remain on the display and are visually demonstrated in the workout profile. By
pressing STOP again you return to the main menu.
In MANUAL mode you select any minimum/maximum workload. The workload limits are as
follows (depending on the device):
Power Range
1
15
- 600 W
1
*
: Presetting = 25W; can be reduced to 15W by pressing the MINUS button.
Please note that the resistance range below 25 W is not defined in the DIN VDE 750-238
standard!
3 6
Technical and visual modifications as well as misprints reserved
Increments
5 W
-
Operation
Speed
20 - 120 rpm
© 2017 by ERGO-FIT GmbH & Co. KG
Advertisement
Chapters
Table of Contents
