Setting Presets; Re-Recording A Preset; Pre-Configured Presets - ETC ColorSource PAR Pearl Installation Manual

ETC Installation Guide
ColorSource PAR Pearl v1.7

Setting presets

There are twelve factory-configured presets built into the fixture. From the
Presets menu, press the Up and Down buttons to scroll through the list. The
preset plays immediately upon selection. All presets can be re-recorded
through an RDM device.

Re-recording a preset

1:
2:
3:
4:
Note: When the fixture is in Direct mode (
It is possible to activate a known preset from a connected fixture when DMX
is not present. If a connected fixture activates a preset that is not recognized
by the fixture, the fixture will hold its last look. When DMX is restored, the
DMX takes priority.

Pre-configured presets

Preset
1
2
3
4
5
6
ColorSource PAR Pearl v1.7
Using DMX, set the desired levels.
Press the Mode button to access the Presets menu.
Using the Up and Down buttons, navigate to the preset number that
you want to re-record.
Press and hold the Mode button for 3 seconds to confirm the preset
selection. The user interface will show a 3-second countdown. The
preset number blinks once to confirm that the preset has been
recorded.

mode (
See
Changing the DMX control mode
Name
3000K White
3200K White
3500K White
4000K White
4200K White
4500K White
), you cannot re-record presets.
Preset
7
8
9
10
11
12
Page 10 of 16

) or 1-channel
on
page 7.
Name
4700K White
5000K White
5200K White
5600K White
6000K White
6450K White
ETC