General Technical Data - GE AF-600 FP Operating Instructions Manual

Specifications

10.2 General Technical Data

Mains supply (L1, L2, L3):
Supply voltage
Mains voltage low / mains drop-out:
During low mains voltage or a mains drop-out, the drive continues until the intermediate circuit voltage drops below the
minimum stop level, which corresponds typically to 15% below the drive's lowest rated supply voltage. Power-up and full torque
cannot be expected at mains voltage lower than 10% below the drive's lowest rated supply voltage.
Supply frequency
Max. imbalance temporary between mains phases
True Power Factor ()
Displacement Power Factor (cos) near unity
Switching on input supply L1, L2, L3 (power-ups) ≤ unit size 1x
Switching on input supply L1, L2, L3 (power-ups) ≥ unit sizes 2x, 3x
Switching on input supply L1, L2, L3 (power-ups) ≥ unit sizes 4x, 5x, 6x
Environment according to EN60664-1
The unit is suitable for use on a circuit capable of delivering not more than 100.000 RMS symmetrical Amperes, 480/600 V
maximum.
Motor output (U, V, W):
Output voltage
Output frequency
Switching on output
Accel/Decel Times
*
Dependent on power size.
Torque characteristics:
Starting torque (Constant torque)
Starting torque
0 10
Overload torque (Constant torque)
*Percentage relates to the frequency converter's nominal torque.
Cable lengths and cross sections:
Max. motor cable length, screened/armoured
Max. motor cable length, unscreened/unarmoured
Max. cross section to motorand mains*
Maximum cross section to control terminals, rigid wire
Maximum cross section to control terminals, flexible cable
Maximum cross section to control terminals, cable with enclosed core
Minimum cross section to control terminals
* See 10.1 Power-dependent Specifications for more information!
Digital inputs:
Programmable digital inputs
Terminal number
Logic
Voltage level
Voltage level, logic'0' PNP
Voltage level, logic'1' PNP
Voltage level, logic '0' NPN
Voltage level, logic '1' NPN
Maximum voltage on input
Input resistance, R
All digital inputs are galvanically isolated from the supply voltage (PELV) and other high-voltage terminals.
1) Terminals 27 and 29 can also be programmed as output.
66
AF-600 FP Operating Instructions
i
200-240V ±10%, 380-480V ±10%, 525-600V ±10%,
3.0% of rated supply voltage
≥ 0.9 nominal at rated load
maximum twice/min.
maximum once/2 min.
overvoltage category III / pollution degree 2
0 - 100% of supply voltage
maximum 110% for 1 min.
maximum 135% up to 0.5 sec.
maximum 110% for 1 min.
2
1.5 mm /16 AWG (2 x 0.75 mm
18, 19, 27
50/60Hz ±5%
(> 0.98)
maximum once/min.
*
0 - 1000 Hz
Unlimited
1 - 3600 sec.
*
*
*
150 m
300 m
2
)
2
1 mm /18 AWG
2
0.5 mm /20 AWG
2
0.25 mm
4 (6)
1)
, 29, 32, 33,
PNP or NPN
0 - 24V DC
< 5V DC
> 10V DC
> 19 V DC
< 14V DC
28V DC
approx. 4kΩ