Mitsubishi Electric MELSEC iQ-R Series User Manual page 107

Common program
The following figure shows an example of the program to check the data link status of the remote head module (station
number 1).
(0) Checks the data link status of the remote head module (station number 1).
After creating the program examples shown later, add the MCR instruction to the end of the program as shown below.
Program example 1
In this program example, the count operation starts when CH1 Count enable turns on and stops when CH1 Count enable
turns off.
(6) Turns on 'CH1 Count enable' (Y1018).
(27)Turns off 'CH1 Count enable' (Y1018).
Program example 2
In this program example, CH1 Accumulating counter comparison flag is reset.
(50)Turns on 'CH1 Comparison signal reset request' (Y1010).
(74)Turns off 'CH1 Comparison signal reset request' (Y1010).
Appendix 4 Operation Examples of When the Remote Head Module Is Mounted
A
APPX
105