Mitsubishi Electric MELSEC iQ-R Series User Manual page 66

CH1 Comparison signal reset request
To turn off 'CH1 Accumulating counter comparison flag' (X10), turn on and off this signal corresponding to the relevant
channel.
For the timing of turning on and off the signal, refer to the following.
Page 62 CH1 Accumulating counter comparison flag
■Device numbers
The following shows the device numbers of this output signal.
Signal name
CH Comparison signal reset request
■Operation timing
The change is enabled while the signal is on.
CH1 Count enable
Turn on this signal to start the count operation.
Turning on this signal starts the count operation and stores values in the following buffer memory areas.
• 'CH1 Sampling pulse number' (Un\G0)
• 'CH1 Accumulating count value' (Un\G2, Un\G3)
• 'CH1 Input pulse value' (Un\G4, Un\G5)
When this signal turns off, the count operation stops.
For the timing of turning on and off the signal, refer to the following.
Page 60 Operating condition setting complete flag
■Device numbers
The following shows the device numbers of this output signal.
Signal name
CH Count enable
■Operation timing
The change is enabled while the signal is on.
APPX
64
Appendix 2 I/O Signals
CH1 CH2 CH3
Y10 Y11 Y12
CH1 CH2 CH3
Y18 Y19 Y1A
CH4 CH5 CH6
Y13 Y14 Y15
CH4 CH5 CH6
Y1B Y1C Y1D
CH7 CH8
Y16 Y17
CH7 CH8
Y1E Y1F