Table of Contents
Advertisement
OPTION menu
OPTION menu
Item
AUTO SEARCH
DIRECT POWER
ON
AUTO POWER
OFF
(continued on next page)
58
Turns on/off the automatic signal search function.
ON ó OFF
When the ON is selected, detecting no signal automatically cycles
through input ports in the following order. The search is started from
the current port. Then when an input is found, the projector will stop
searching and display the image.
HDMI 1
DVI-D ï SDI ï HDBaseT ï COMPUTER IN2
Turns on/off the DIRECT POWER ON function.
ON ó OFF
When set to the ON, the light source in projector will be automatically
turned on without the usual procedure (24), only when the projector
is supplied with the power after the power was cut while the light source
was on.
• This function does not work as long as the power has been
supplied to the projector while the light source is off.
Turns on/off the function to turn off the projector automatically in 20
minutes when no signal or sync out.
ON ó OFF
If one of the projector's buttons or the remote control buttons
is pressed or one of the commands (except get commands) is
transmitted to the CONTROL port during the corresponding time,
projector will not be turned off.
Refer to the section Turning off the power (24).
Description
HDMI 2
COMPUTER IN1
Advertisement
Table of Contents
