ESAB A2 Instruction Manual page 64

9 TOOLS
The following values can be selected:
• arc voltage: min, max
• wire feed speed: min, max
• welding current: min, max
• travel speed: min, max
• energy per unit length: min, max
Set the desired value using the setting knobs and press STORE.
In the dialogue box, you are asked if you want to store the selected storage point. Press
YES to save the value. The storage point's values can be seen under the line at the bottom.
With the AUTO soft key, the parameters are set automatically according to the most recently
used measurement values.
When asked if the measurement values are to be set automatically, press NO or YES and
then STORE if the setting is to be retained.
0460 949 274 - 64 - © ESAB AB 2015