ESAB A2 Instruction Manual page 48

8 CONFIGURATION MENU
Specify the values to weld with two welding heads as follows:
Position the cursor on the WELDING HEAD row. Select whether the setting is to apply to
"master" control unit HEAD or "slave" control unit TAIL.
• Position the cursor on the WELD HEAD OFFSET row and specify the distance between
the two welding heads.
Example, I/O ON
WELD HEAD OFFSET
•
Press Start,
• Welding head 1 starts to weld.
• Welding head 2 only starts welding when the start position for welding head 1 has been
reached (the distance given in WELD HEAD OFFSET.
•
Press Stop, for welding head 1.
• Welding head 1 stops welding but continues travelling.
• Welding head 2 stops welding once it reaches the point where equipment1 stopped
welding (the distance given in WELD HEAD OFFSET.
• Welding is complete.
0460 949 274
Welding head 2 (slave)
TAIL
for welding head 1.
- 48 -
Welding head 1 (master)
HEAD
© ESAB AB 2015