Ricoh Ri 1000 User Manual page 41

❖ If an obstruction is detected a message will appear.
❖ Press the EJECT
cleared.
❖ Note: Having the table too far away will affect image quality. Ideally the garment will be
1.5mm away from the print head. When initially setting the table height, you should raise
the table until you get the obstruction detected message then only lower the table slightly.
Once the table height has been set in this way you should not need to adjust the table
height again unless you are changing the substrate you are printing on (from T-shirt to
sweat shirt for example)
❖ For this reason, when you get an obstruction message, you should always try to flatten the
garment to clear the obstruction before lowering the table.
❖ Caution: Having the head too far away from the printing surface in addition to causing poor
prints can interfere with the encoder function and cause an error due to excessive ink mist.
It can also cause damage to other components due to excessive ink mist. It is important
when changing from a thicker fabric to a thinner fabric that the table height be adjusted.
button, then the SET to confirm the obstruction has been
RICOH Ri 1000
User Manual
41