Kannad 406 AF-COMPACT Installation Manual page 31

INSTALLATION MANUAL OPERATION MANUAL INSPECTION LOG
(c) Weight
Approx. 40 gr. (0.088 lbs).
(2) Electrical Characteristics
The RC200 RCP is energized by the ELT when the ELT's switch is on
ARM position.
- Switch:
• ON / ARM / RESET-TEST 3-position switch.
• Type of contacts: alloyed silver.
• Conductive material: Silver-plate alloyed copper.
• RESET: unstable position
- Led annunciator:
• Color: red.
• Peak - Wavelength: 635 nm.
• Viewing angle: 50 degrees.
(3) Electrical Interfaces
A single male 9-pin D-SUB connector (J1) enables to connect the RC200
remote control panel to the KANNAD 406 AF-COMPACT with a 3-wire
cable (AWG 24, shielded recommended).
On the ELT side, the wires are soldered to a male DIN 12 connector.
On the RCP side, the wires are connected to a female 9 pin D-SUB
connector.
Sub-D 9 Pts Male
Viewed from
Front Face
Note: (1) RCP buzzer functionnality not featured by this model.
KANNAD 406 AF-COMPACT
Signal name
1
2 RCP BUZZER
3 BUZZER GND
4 RCP RESET
5 RCP ON
6
7
8 RCP COMMON
9 RCP LED
Table 2: J1, D-SUB 9 Pts Male Pin-out
Not used with KANNAD AF Compact
(1)
ELT
(1)
BUZZER
ELT
ELT
Not used with
KANNAD 406 AF-Compact
ELT
ELT
Destination
PAGE: 111
FEB 01/2008