Kannad 406 AF-COMPACT Installation Manual page 27

INSTALLATION MANUAL OPERATION MANUAL INSPECTION LOG
(a) J1
DIN 12 socket J1 is dedicated for connection to the Remote Control Panel,
to a Programming or Maintenance Dongles and/or to a programming
equipment (PR600).
IMPORTANT: Shielded cables are recommended. The required wires
are AWG24.
J1
Viewed from
Front Face
(b) J2
BNC female connector J2 is used to connect the outside antenna through a
50 Ω coaxial cable.
IMPORTANT: The length of the coaxial cable should not exceed 2 meters (6
ft) for a standard RG58 or equivalent coaxial cable. If the cable length
exceeds 2 meters, a low loss cable of attenuation less than 1 dB must be
used (See Important notice Section D. Outside antenna, page
KANNAD 406 AF-COMPACT
PIN Signal Name
J1-A RCP TEST/RESET RCP
J1-B DONGLE RX
J1-C DONGLE CS
J1-D DONGLE SK
J1-E DONGLE TX
J1-F DONGLE ALE2P
J1-G RCP COMMON
J1-H RCP BUZZER
J1-J RCP LED
J1-K N/C
J1-L DONGLE GND
J1-M N/C
Table 1: J1 connector pin-out
Destination Direction
IN
SMM / PGM IN
SMM OUT
SMM OUT
SMM / PGM OUT
SMM OUT
RCP OUT
Not used
RCP OUT
SMM / PGM OUT
6).
FEB 01/2008
PAGE: 107