Connection - Kannad 406 AF-COMPACT Installation Manual

INSTALLATION MANUAL OPERATION MANUAL INSPECTION LOG

(3) Connection

Fabricate a 3-wire bundle (AWG 24, shielded preferred) long enough to
reach between the ELT installation location and the cockpit panel RCP
location.
Slide heat-shrinkable sleeves on both sides of each wire.
On the ELT side:
- Solder the wires to the DIN12 connector supplied with the pack:
• solder the wires to pins G (RCP COMMON), A (RCP RESET) and J
(RCP LED) of the connector.
• Put heat-shrinkable sleeves to protect the pins
On the RCP side:
- Strap pins 4 and 5 of the female 9-pin D-SUB connector supplied with
the pack.
- Solder the wires to the female 9-pin D-SUB connector as follows:
• Pin 8 (RCP COMMON) has to be connected to Pin G (RCP
COMMON) of the ELT;
• Pin 4 (RCP RESET) has to be connected to Pin A (RCP RESET) of
the ELT;
• Pin 9 (RCP LED) has to be connected to Pin J (RCP LED) of the ELT.
• Put heat-shrinkable sleeves to protect the pins.
- Connect the female 9-pin D-SUB connector to the male 9-pin D-SUB
socket of the RC200.
KANNAD 406 AF-COMPACT
Figure 207: Wiring of 3-wire bundle
PAGE: 212
FEB 01/2008