Kannad 406 AF-COMPACT Installation Manual page 70

INSTALLATION MANUAL OPERATION MANUAL INSPECTION LOG
- Protecting the battery pack
NOTE: A foam is supplied with the battery kit. This foam, composed of four
leaves attached together and covered by adhesive , is used to protect the
battery pack when installed in the housing. This foam must be stuck
around the battery pack.
1. Remove the adhesive from the foam.
2. Position the foam as to put the wire of the battery through the
rectangular notch of the foam.
3. Fold and stick the first leaf of the foam (at the right of the notch) on the
right side of the battery pack.
4. Stick the second leaf of the foam onto the front of the battery pack.
5. Fold and stick the third part of the foam onto the left part of the battery
pack.
6. Fold and stick the fouth part of the foam onto the rear of the battery
pack.
This leaf must also cover the end of the first leaf on the right side of
the battery pack.
Figure 203: Protecting the Battery pack
KANNAD 406 AF-COMPACT
PAGE: 608
FEB 01/2008