Optional Control Modules - Extron electronics MLC 104 IP Plus Series User Manual

Optional Control Modules

The MLC can "learn" IR commands from the remote control of a VCR, DVD, or other device,
allowing you to create an IR driver file that can be incorporated into the MLC event scripts. A
command can be associated with each of the buttons on an optional infrared control
module (such as the Extron CM-5BB, CM-9BLB, or
IRCM-DV+) in order to allow limited control of source devices.
A total of four control modules (a maximum of four control
module addresses) can be installed with this MLC (see
figure 3). See the Control Modules User's Manual and the
IRCM‑DV+ Control Module User's Manual for installation
details and see the Global Configurator
Help file to learn about configuration. See
the
IRCM-DV+
IR commands are transmitted from the
Display RS-232/IR port and IR ports
on the MLC (via IR Emitters) when the
corresponding button is pressed on
the front panel of the controller, SCP, or
control module. See the Control Modules
User's Manual.
special SIS commands for the
on page 101.
CM-5BB
CM-20BB
Figure 3. Optional IRCM and CM
Control Modules
MLC 104 IP Plus Series • Introduction
DVD & VCR CONTROL
Tx
DVD VCR
TITLE MENU
TUNER
ENTER TV/VCR
PREV/REW PLAY NEXT/FWD PAUSE STOP
IRCM-DV+
CM-3BLB
CM-3BLB
CM-9BLB
CM-9BLB
5