Table of Contents
Advertisement
Resources
Obtaining Control Drivers
Extron provides an extensive selection of device
drivers available on the Extron Website. If the
system requires a control driver that is not already
available, you can request a new serial (RS-232) or
Ethernet driver from Extron.
Locating Software, Firmware, and Driver Files on the Extron Website
There are three main ways to find software, firmware, and device drivers within www.extron.com:
Via links from the Web page for the specific product
•
Via the
Download
page (Click on the Download tab at the top of any page within www.extron.com.)
•
Via links from search results
•
NOTE:
To obtain Global Configurator (available to run in GC Plus mode) software, you must have an Extron Insider account
and contact an Extron support representative. Extron provides training to our customers on how to use the software.
Access to Global Configurator Professional is available to users who successfully complete Extron Control Professional
Certification.
NOTE:
New RS-232 and Ethernet drivers are required. You must use serial and Ethernet drivers developed specifically
for the IP Link Pro platform. With the exception of IR device drivers, drivers used for the previous generation IP Link
(non-Pro) controllers are not compatible.
Removing the MLC Plus EU or MK from the Mounting Surface
Before you can replace buttons or faceplates on an MLC Plus 84 EU or MK, if the unit is installed in a wall or furniture,
you must remove the unit from the metal mounting bracket and installation surface. To help with this task, Extron
provides a removal tool (shown at right) with the unit. Use only this provided removal tool.
To remove the MLC Plus 84 EU or MK from the mounting surface:
Insert the flat tip of the removal tool in the center of the right or left
1.
edge of the MLC Plus, between the faceplate and wall
frame.
Push the tool into the gap until the line on the tool
2.
aligns with the edge of the faceplate.
Press (angle) the removal tool outward from the MLC,
3.
toward the mounting surface (as shown in the figure
at right) to release the tab that secures the MLC Plus
within the wall frame.
Repeat steps 1 and 2 on the opposite side of the
4.
MLC Plus. The unit should tilt out from the frame.
NOTE:
The wall frame is removed at the same
time you remove the MLC Plus from the
bracket and mounting surface.
Obtaining Instructions, Information, and Assistance
A checklist of basic setup steps is provided in this guide. For
additional information see the help files and the MLC Plus 84 Series
User Guide, available at www.extron.com.
If you have questions during installation and setup, call the
Sales & Technical Support Hotline
Systems Support Hotline (1.800.633.9877).
M E
M E
L U
L U
V O
V O
Insert to line.
1,2
Inserting and Pressing the Removal Tool
Figure 17.
Extron S3
or the Extron S3 Control
3
11
Advertisement
Table of Contents
