Unpacking; Assembly - Jet SBR-30M Operating Instructions And Parts Manual

6.2 Unpacking

Open shipping container and check for shipping
damage. Report any damage immediately to your
distributor and shipping agent. Do not discard any
shipping material until
machine is assembled and running properly.
Compare the contents of your container with the
following parts list to make sure all parts are intact.
Missing parts, if any, should be reported to your
distributor. Read the instruction manual thoroughly
for assembly, maintenance and safety instructions.
Contents of Shipping Container
1 Shear, Brake and Roll machine
2 Handle assemblies
2 Guide rods with hex nuts
1 Guide plate
2 Mounting Blocks with T-handles
1 Instructions and Parts Manual
1 Warranty Card

6.3 Assembly

Tools required for setup and assembly:
5, 6, 8mm hex keys ("Allen wrenches")
19mm open end wrench
1. Finish removing crate from around machine.
2. Remove bolts holding machine to pallet.
3. Carefully clean all rust protected surfaces with
a mild solvent or kerosene and a soft rag. Do
not use lacquer thinner, paint thinner, or
gasoline, as these may damage painted
surfaces.
4. Coat all machined surfaces with a very light
film of oil to inhibit rust.
5. Carefully move machine to a work bench or
stand. Machine location must allow free
access on all sides.
6. Bolt machine to stand or workbench. The
stand or workbench must be bolted to the
floor.
(NOTE: An optional stand is available for this
machine; see Section 9. Contact your JET
distributor to order.)
7. Remove one handle (A, Figure 3) from each
operating handle assembly, using 8mm hex
key.
the Shear/Brake/Roll
8. Loosen lock bolt (C, Figure 3).
9. Slide bar (B) into hub and tighten lock bolt (C)
to secure.
10. Re-install handle (A).
11. Install both guide rods into either the upper or
lower set of threaded holes (Figures 4/5) and
tighten the setting by rotating hex nut against
the cast base of the machine with 19mm
wrench.
(Brake position)
(Shear position)
8
Figure 3
Figure 4
Figure 5