Table of Contents
Advertisement
Unpacking and Cleanup
1. Finish removing all contents from the shipping
container. Do not discard any shipping
material until the shaper is set up and running.
2. Inspect contents for shipping damage and
report any damage or missing parts to your
distributor.
3. Clean all protected parts with kerosene. Do
not use gasoline, paint thinner, or any
cellulose-based solvent. These will damage
painted surfaces and melt plastic.
Tools Required for Assembly
3mm Angle Wrench
12/14mm Wrench
Contents of the Shipping Container
1
Shaper
Accessory Package
1
Dust Chute
1
Miter Gauge
1
Draw Bar & Nut
1
1/2" Spindle Assembly
1
3/4" Spindle Assembly
1
1/4" Router Collet
1
1/2" Router Collet
1
Arbor Wrench
1
3mm Hex Key Wrench
1
12mm / 14mm Open End Wrench
Dust Chute Assembly
Install dust chute to the fence body with two
3/8"-16 x 3/4" Hex Cap Screw (A, Fig. 1).
8
Figure 1
Advertisement
Table of Contents
