Introduction; Specifications; Unpacking; Contents Of The Crate - Jet SBR-30N Operating Instructions And Parts Manual

Introduction

This manual is provided by Walter Meier (Manufacturing) Inc., covering the safe operation and
maintenance procedures for a JET Model SBR-30N and Model SBR-40N Shear, Brake and Roll. This
manual contains instructions on installation, safety precautions, general operating procedures,
maintenance instructions and parts breakdown. This machine has been designed and constructed to
provide years of trouble free operation if used in accordance with instructions set forth in this manual. If
there are any questions or comments, please contact either your local supplier or Walter Meier. Walter
Meier can also be reached at our web site: www.waltermeier.com.

Specifications

Model Number ................................................................. SBR-30N....................................... SBR-40N
Stock Number .................................................................... 754031.......................................... 754041
Capacity - Mild Steel (ga.) ........................................................... 20.................................................. 20
Base Dimensions (LxW)(in.) ..................................... 32-1/4 x 14-1/2...............................45-1/4 X 17-3/4
Overall Dimensions, Assembled (LxWxH)(in.) ................ 41 x 15 x 24.............................. 56 x 19 x 27-1/2
Net Weight, approximate (lbs.)................................................... 300................................................ 651
Shipping Weight, approximate (lbs.) ........................................... 324................................................ 682
Shearing:
Shearing Capacity ..................................................... 20 ga. x 30 in. ................................20 ga. x 40 in.
Shear Blade .................................................................... reversible....................................... reversible
Bending:
Bending Capacity ......................................................20 ga. x 30 in..................................20 ga. x 40 in.
No. of Male Dies ........................................................................... 6.................................................... 8
No. of Female Dies ....................................................................... 5.................................................... 7
Width of Upper Dies (in.) .......................................... 1, 2, 3, 6, 8, 10...........1, 1-1/2, 2, 2-1/2, 4, 7, 10, 15
Upper Die Height (in.) ............................................................. 4-3/8.............................................. 3-3/8
Rolling:
Rolling Capacity ........................................................20 ga. x 30 in..................................20 ga. x 40 in.
Wire Grooves (dia./in.) ................................................ 1/8, 3/16, 1/4.................................. 1/8, 3/16, 1/4
Size of Slip Rolls (in.) ............................................. 1-1/2 Dia. x 30 L............................. 1-5/8 Dia. x 40 L
Minimum Forming Radius (in.) .................................................... 3/4.................................................... 1
The above specifications were current at the time this manual was published, but because of our policy of
continuous improvement, Walter Meier reserves the right to change specifications at any time and without
prior notice, without incurring obligations.

Unpacking

Open shipping crate and check for shipping
damage. Report any damage immediately to
your distributor and shipping agent. Do not
discard any shipping material until the Shear,
Brake and Roll is assembled and running
properly.
Compare the contents of your crate with the
following parts list to make sure all parts are
intact. Missing parts, if any, should be reported
to your distributor. Read the instruction manual
thoroughly for assembly, maintenance and
safety instructions.

Contents of the Crate

1 Shear, Brake and Roll Machine
1 Operating Lever Assembly
2 Guide Rods with hex nuts
1 Guide Plate
1 Instruction and Parts Manual
1 Warranty Card
5