Unpacking - Jet JJ-6CSDX Operating Instructions And Parts Manual

5.0 Unpacking

This unit is shipped in two cartons. Open both
cartons and check for shipping damage. Report
any damage immediately to your distributor and
shipping agent. Do not discard any shipping
material until the Jointer is assembled and running
properly.
Compare the contents of your cartons with the
following parts list to make sure all parts are intact.
Missing parts, if any, should be reported to your
distributor. Read the instruction manual thoroughly
for assembly, maintenance and safety instructions.
Refer to Figures 5-1, 5-2, 5-3.
Stand Carton
1 Stand with Motor
1 Stand Cover with Mounting Hardware
1 Dust Chute with Mounting Hardware
1 Pedestal Switch with Mounting Hardware (JJ-
6HHDX only)
Main Unit Carton
1 Bed Assembly
1 Fence Assembly
1 Cutterhead Guard (A)
1 Belt Guard (E)
1 V-Belt (D)
4 1/4-20 x 1/2 Pan Head Screws (L)
4 1/4 Flat Washers (M)
1 Lock Handle, Flat Washer, and Lock Nut for
Fence (G)
1 Fence Handle (F)
3 Lock Bolts (B)
3 3/8" Lock Washers (C)
2 Handwheel Assembly (N)
2 Push Blocks (K)
1 Operating Instructions and Parts Manual
1 Warranty Card
Tools Included for JJ-6CSDX
1 12/14mm Open End Wrench (O)
1 8/10mm Open End Wrench (P)
1 3mm Hex Wrench (Q)
1 4mm T-Hex Wrench
1 8mm Hex Wrench
Tools included for JJ-6HHDX:
1 12/14mm Open End Wrench (O)
1 8/10mm Open End Wrench (P)
1 3mm Hex Wrench (Q)
1 6mm Hex Wrench
2 Star Point Screwdrivers (R)
5 Knife Inserts (S)
10 Knife Insert Screws (T)
Figure 5-1: Stand carton
5-2: Main Unit Carton
5-3: Tools included for Model JJ-6HHDX only
7