Through-Hole Labels; Ink Cartridge - Brady BradyJet J2000 User Manual

Setup
Install or Change Supplies

Through-Hole Labels

If you are using label supply that has a hole punch or a notch to identify a transition from backing to
label, you can adjust the sensor bar to position it over the identifying mark. If the sensor is too far to the
right or the left the printer will still sense the label but the image may be offset downward because the
printer will start printing at the wrong position.
The sensor bar has a guide in inches and millimeters that will help you identify where to set the bar to
align the sensor over any identifying mark. To do this, measure the distance from the edge of the label
supply to the correct position on the supply. Set the gap sensor bar to this measurement.
Center of Hole
Through-Hole Labels
To adjust the gap sensor position use a pen to
move the slide bar to the correct position.

Ink Cartridge

When the cartridge reaches 10% remaining
you will be prompted via the Status Monitor to
replace the cartridge. If quality still looks
acceptable you can choose to ignore this
warning. However, you may waste labels if
the cartridge runs out of ink before the next
warning at 0%. When you choose to replace
the cartridge follow the procedure below.
After installing a new cartridge, you may choose to run an alignment print to achieve maximum quality.
However, this will require canceling the print job. If you would like to enable smooth transitions
BradyJet J2000 Color Label Printer
9