Power; Install Or Change Supplies - Brady BradyJet J2000 User Manual

Power

1. Plug the power cord into the power input port on the back of the printer.
2. Plug the other end of the power cord into an AC power outlet.
3. Turn the power switch on.

Install or Change Supplies

The BradyJet J2000 Color Label Printer utilizes a variety of Brady label supply. As long as the label
supply can receive ink jet printing and is within the allotted size, it will work in the printer.
1. Open the top cover.
2. Pull the spring loaded label supply guide out far enough to fit the label supply.
3. Remove any shipping tape from the label supply roll to ensure that it can unroll freely, making
certain that no adhesive portion is exposed.
IMPORTANT!
Note: If using label supply other than standard square / rectangular die cut labels, see
the Supply Gap Sensor" on page
BradyJet J2000 Color Label Printer
Exposed adhesive surface can attach itself to the inner workings of the print
mechanism and cause a jam.
Label Supply Guide
8.
Setup
Power
Adjusting
5