Brady BradyJet J2000 User Manual page 23

Left Margin Offset This value moves the printed label left or right.
• Add to the current value to move the printed label to the right.
• Subtract from the current value to move the printed label to the left.
After adjusting the value, click the "set" button to send the value to the printer.
IMPORTANT!
Top of Form (TOF) This value moves the print start position up or down on the label. If fine tuning is
needed, increase this setting to move the image down on the label or decrease to move the image up
on the label. The unit of measure is 0.1mm.
• Add to the current value to move the printed label down or toward the printer.
• Subtract from the current value to move the printed label up or away from the printer.
After adjusting the value click the "set" button to send the value to the printer.
Left Offset
BradyJet J2000 Color Label Printer
Before adjusting this value make sure the label supply is properly loaded so that
there is no gap between the edge of the liner and the fixed throat guide. Any gap at
this point will greatly affect the left margin offset value needed to align the label.
Also, if you adjust the value with improperly loaded label supply you will have to
adjust it again if you load the label supply correctly the next time.
You may have to make several adjustments to one or more of these
values. After each adjustment you can click the test button to print a
small test pattern on the label. This will help you find the proper
alignment value.
TOF
10 units
1.0 mm
Using System Tools
Adjusting Label Offsets
17