Adjusting The Supply Gap Sensor - Brady BradyJet J2000 User Manual

Setup
Install or Change Supplies

Adjusting the Supply Gap Sensor

The supply gap sensor "sees" the gap between label supply by shining light from the top of the label
and attempting to read that light from a sensor on the bottom. By default, this sensor is set to read the
gap 0.5" from the left side of the label supply. If the gap in your label supply intersects with the gap
position, as shown on the slide bar, you do not need to adjust this and you can skip this section. This
does not need to be adjusted for most label supply.
Gap Between Labels
Intersection Point
Gap Sensor Position
If you are using label supply other than standard square / rectangular die-cut labels such as through-
hole supply, use the instructions below to adjust the supply gap sensor.
Gap Sensor Slide Bar
BradyJet J2000 Color Label Printer
8