Advertisement
IMPORTANT!
Check the ink pads periodically for excessive ink saturation and replace when necessary.
Note: It is recommended to replace the ink pads after 20,000 prints.
Order Ink Pad Replacement Kit J20-PAD
1. Turn off power and remove power cord.
2. Carefully turn printer over and remove the two screws on the
metal cover.
3. Remove old felt pad and foam strip.
4. Fold new foam pad and fit into channel as shown.
Ink Pad Replacement
Quick Start Guide
Foam Strip
Advertisement
Table of Contents
Related Manuals for Brady BradyJet J20-PAD
Summary of Contents for Brady BradyJet J20-PAD
- Page 1 Ink Pad Replacement Quick Start Guide Felt Pad Foam Strip Felt Strip IMPORTANT! Check the ink pads periodically for excessive ink saturation and replace when necessary. Note: It is recommended to replace the ink pads after 20,000 prints. Order Ink Pad Replacement Kit J20-PAD 1.
- Page 2 10. Slide the end of the felt strip without notches into opening, as shown. 11. Fold felt strip down into trough so small tabs fit into notches on felt. 12. Use a needle-nose pliers or similar tool to press felt securely into place. © 2018 Brady Corporation. All Rights Reserved.
Need help?
Do you have a question about the BradyJet J20-PAD and is the answer not in the manual?
Questions and answers