Detection Of The Jig Location - Roland DWX-30 User Manual

Detection of the Jig Location

WARNING
WARNING
Carry out "Detection of the jib location" in order to determine the reference position for cutting.
Important !
 Detecting the location of the jig is a necessary procedure for determining the reference position for cut-
ting. Be sure to carry this out when you use the machine for the first time after purchase or whenever you
change the jig.
 Make sure the clamp, detection pin, tool sensor, and attachment for detection are clean and free of dust,
chips, and the like. Any buildup on these may prevent correct response by the sensor and make correct
detection of the jig location impossible. In some cases, such buildup may cause breakage of the detection
pin, resulting in injury or damage.
Procedure

Close the front covers and press the VIEW button.
 P. 57, "Moving to the VIEW Position"


Install the detection pin.
 P. 76, "Installing a Tool"
Never inadvertently touch the computer or handy panel while performing
this task.
Unintended operation of the machine may result in injury.
Securely fasten the jig in place. After securing in place, make sure no
wrenches or other articles have inadvertently been left behind.
Otherwise such articles may be thrown from the machine with force, posing
a risk of injury.
4-1 Before Starting Operations
Open the front covers and remove the dust
collection capsule.
Chapter 4 Performing Cutting
67