Table of Contents
Advertisement
Starting Cutting
Send cutting data from the computer and start cutting. The feed rate and the speed of spindle rotation are
determined by the cutting data received.
Before Starting Cutting
Make sure that the following procedures have finished. If these procedures have not finished, the intended
cutting may not be possible.
Detection of the jig location
P. 67, "Detection of the jig location"
Tool Length Measurement
P.77, "Tool Length Measurement"
Procedure
Verify that the cover of the dust collection capsule is properly attached.
Close the front covers.
Send cutting data from the computer and start cutting.
When the tool type has been changed during cutting, measure the tool length again and resume cut-
ting.
P.77, "Tool Length Measurement"
When cutting has finished, press the VIEW button.
P. 57, "Moving to the VIEW Position"
Open the front covers and remove the workpiece.
This completes the cutting. After removing the workpiece, trim away any excess areas.
4-2 Preparation for and Performing Cutting
Chapter 4 Performing Cutting
79
Advertisement
Table of Contents
