Table of Contents
Advertisement
2-5 Connecting Multiple Units
Restart VPanel.
After VPanel is restarted, the assigned ID is enabled,
You can connect all the machines of which the setting has been done to the computer by USB cables. At this
point, if you connect the machines with a same ID at the same time, the computer might shut down.
When you connect the third and fourth machines, turn off the power of all the ma-
chines, disconnect the USB cables from the computer, and exit "VPanel."
Repeat the above steps
To confirm the set ID
46
Chapter 2 Installation and Setup
to
.
Click the [Setup] in VPanel and confirm
[Machine ID] in the [Modeling Machine]
tab.
Select an ID and press [Set ID], and the ID is
changed. Note that the changed ID is enabled
if you restart the machine with this setting.
Advertisement
Table of Contents
