Table of Contents
Advertisement
3-4 Pausing and Quitting Cutting
Important !
Before opening the front cover while operation is paused, first make sure that rotation of the spindle is stopped.
For safety, opening the front cover while the spindle is turning makes the machine perform an emergency stop.
Be sure to note that if this happens, it's necessary to quit the operation and start over from the beginning.
P. 53, "Emergency Stop Due to Opening or Closing the Front Cover"
Other Operations Possible While Paused
VPanel
Tool movement using manual feed
P. 54, "Manual Feed"
Starting or stopping spindle rotation
P. 58, "Starting and Stopping Spindle Rotation"
Changing the spindle speed
P. 80, "Override"
Adjusting the tool feed rate
P. 80, "Override"
Handy Panel
Starting or stopping spindle rotation
P. 62, "Using the Handy Panel"
Moving the tool
P. 62, "Using the Handy Panel"
60
Chapter 3 Basic Operation
Chapter 3 Basic Operation
Hold down the PAUSE button for one sec-
ond or longer.
The tool returns to the position where operation
was paused, and cutting resumes. After the tool
starts moving, the READY light flashes until cut-
ting resumes. After cutting resumes, the PAUSE
light goes dark.
This operation cannot be performed while a front
cover is open. Close the front cover, then perform
the operation.
Advertisement
Table of Contents
