Table of Contents
Advertisement
Once switch off the power of the machine, and then switch on the main power and the
sub power again.
The assigned ID is recognized by the machine. If the ID is assigned for the first time, a corresponding
driver is required.
Windows 7: The required driver is automatically created.
Windows Vista/XP: A message to prompt the user to install the Windows driver is displayed. Install the
driver in accordance with the message.
P.41, "Installing the Windows-based Driver"
2-5 Connecting Multiple Units
Click the [Modeling Machine] tab.
Select any unused ID in [Machine ID],
and press [Set ID].
Assign an ID to identify the machine on VPanel.
Since A is assigned to the first machine, be sure to
select B, C, or D.
Do not assign a same ID. If you connect the
machines with the same ID at the same time,
the computer might shut down.
Read the message displayed on the screen
as shown in the left, and click [OK].
When the message, "Operation is complete," ap-
pears, click [OK].
Exit VPanel.
Click
.
Chapter 2 Installation and Setup
45
Advertisement
Table of Contents
