Table of Contents
Advertisement
1-2 Part Names and Functions
Front and Interior
Front covers (upper and lower)
The front covers open upward and
downward. To ensure safety, opening
either of these covers during cutting
or spindle rotation causes an emer-
gency stop to occur.
P. 53, "Emergency Stop Due to
Opening or Closing the Front Cover"
Spindle head*
Handy panel
This is a hand-held operation
panel connected to the cutting
machine by a cable.
P. 62, "Using the Handy
Panel"
*NOTE: In this manual, the mechanisms around the spindle unit, including the spindle motor, are called the
"spindle head. " Also, the rotary-axis area inside the spindle unit is called the "spindle. "
Rotary axis unit
Clamp
Built-in panel
This is the operation
panel installed on the
cutting machine.
P. 30, "Handy Panel
and Built-in Panel"
Tool sensor
This is the sensor for
Table
detecting the length of
the tool and the location
of the jig.
Dust collection capsule
The dust collection capsule
prevents cutting dust from
blowing out and helps suction.
The cover can be detached.
* Detach the cover when
detecting the jig location.
P. 67, "Detection of the Jig
Location"
Chapter 1 Getting Started
27
Advertisement
Table of Contents
