Table of Contents
Advertisement
4-2 Preparation for and Performing Cutting
Installing a Tool
This describes how to install a tool for cutting. You can use the same method to install a detection pin.
*NOTE: The tools are optional items.
Important Notes When Selecting a Tool
Select a tool giving careful attention to such matters as the length of the tool and the shape of its tip.
WARNING
WARNING
CAUTION
Procedure
Close the front covers and press the VIEW button.
P. 57, "Moving to the VIEW Position"
When movement to the VIEW position is complete, open the front covers.
Spanner (17mm)
76
Chapter 4 Performing Cutting
Never inadvertently touch the computer or handy panel while performing
this task.
Unintended operation of the machine may result in injury.
Securely fasten the cutting tool and workpiece in place. After securing in
place, make sure no wrenches or other articles have inadvertently been
left behind.
Otherwise such articles may be thrown from the machine with force, posing
a risk of injury.
Caution: cutting tool.
The cutting tool is sharp. To avoid injury, exercise caution.
Spindle unit
Collet
Loosely tighten the collet.
Secure the spindle unit in place using the 17-mm
spanner, then screw in the collet until it is finger-
tight.
To mount the detection pin, use the collet of di-
ameter 4 mm.
Advertisement
Table of Contents
