Connection; Connecting Of Cables - Hamamatsu Photonics C11440-42U30 Instruction Manual

7. CONNECTION

7-1

CONNECTING OF CABLES

Refer to the figure below when connecting the various cables.
Camera(Rear)
①AC adapter
• When you connect cables, turn off the power supply of the camera and the peripheral devices.
• If you use the adjuster pole and the base plate, see each installation manual.
① AC adapter
This is the cord to supply a power supply. Use the accessory AC adapter.
② USB 3.0 interface cable (Option)
This is the cable to connect the USB 3.0 interface connector of the camera and the USB 3.0
interface connector on the computer.
Note
②USB 3.0 interface cable
Do not place the rear panel of the camera, which connectors are located,
•
to be at the bottom (Do not block ventilation openings.).
• Hamamatsu recommends A12046-03 optional USB 3.0 interface cable for this
camera. The camera complies with EMC direction with using A12467-03 USB 3.0
interface cable. Be careful that the camera with other interface cable may not fulfill
the EMC directive requirements.
C11440-42U30/C11440-42U31 Instruction manual_Ver.1.2
USB 3.0 port
Figure 7-1
Computer
13