Connection; Connecting Of Cables; When The Camera Head Is Fixed - Hamamatsu Photonics C11440-10C Instruction Manual

Table of Contents

C11440-10C Ver.1.2

7. CONNECTION

7-1

Refer to the figure when connecting the various cables.

Camera

② CameraLink interface

•

When the cables are connected, confirm the power switch of peripheral device is in the OFF position.

① AC adaptor

This is the cord to supply a power supply. Use the accessory AC adaptor.

② CameraLink interface cable (Option)

This is the cable to connect the camera and the CameraLink interface board on the computer.

Note

7-2

The camera head is fixed by using the fitting screw at the bottom of the camera head.

Fix the camera head with a tool such as a laboratory jack so that a load may not be imposed

to the part of C-mount when the camera is fixed by C-mount.

• Be careful not to allow the fitting screw to enter more than 8 mm from the surface of the mount.

Note

Screwing this in excessively may impair normal operation.

① AC adaptor

cable (Option)

•

Hamamatsu recommends A10514-05 optional CameraLink interface cable for

this camera. The camera complies with EMC direction with using A10514-05

CameraLink interface cable. Be careful that the camera with other interface

cable may not fulfill the EMC directive requirements.

Computer

Figure 7-1

Table of Contents