Connection; Connecting Of Cables - Hamamatsu Photonics C11440-42U Instruction Manual

7. CONNECTION

7-1

CONNECTING OF CABLES

Refer to the figure when connecting the various cables.
Camera (Rear)
• When you connect cables, turn off the power supply of the camera and the peripheral devices.
• If you use the adjuster pole and the base plate, see each installation manual.
CAUT ION
① AC adaptor
This is the cord to supply a power supply. Use the accessory AC adaptor.
② USB 3.0 interface cable (Option)
This is the cable to connect the USB 3.0 interface connector of the camera and the USB 3.0
interface connector on the computer.
Note
① AC adaptor
② USB 3.0 Interface cable
USB 3.0 Interface board
Do not place the rear panel of the camera, which connectors are located,
•
to be at the bottom (Do not block ventilation openings.).
• Hamamatsu recommends A12046-03 optional USB 3.0 interface cable for this
camera. The camera complies with EMC direction with using A12467-03 Camera
Link interface cable. Be careful that the camera with other interface cable may not
fulfill the EMC directive requirements.
C11440-42U/C11440-42U01 Instruction manual_Ver.1.1
Figure 7-1
Computer
13