Table of Contents
Advertisement
3. INSTALLATION
Avoid using or storing this camera in the following places
Places where the temperature is not the operating temperature indicated in the
•
specifications.
Places where the temperature is not the storage temperature indicated in the
•
specifications.
Places where the temperature varies greatly.
•
In direct sunlight or near a heater.
•
Places where the humidity levels are not the operating humidity levels indicated
•
in the specifications and where the system may be exposed to liquid.
Places where the humidity levels are not the storage humidity levels indicated in
•
the specifications and where the system may be exposed to liquid.
Close to a strong source of magnetism or ratio waves.
•
Places where there are vibrations.
•
Places where the system may come into contact with corrosive gases (such as
•
chlorine or fluorine).
Places where there is a lot of dust.
•
How to place the camera (when the camera is placed on a table)
Do not place the camera the rear panel of the camera, which connectors
are located, to be at the bottom. (Do not block ventilation openings.)
Do not block ventilation openings
To prevent overheating in the camera's interior, do not wrap the camera
in cloth or any other material, or in any way allow the camera's
ventilation ports to become blocked. If the camera is being operated in
a closed environment, ensure clearance of at least 10 cm from both the
intake and exhaust vents when setting up.
C11440-42U30/C11440-42U31 Instruction manual_Ver.1.2
5
Advertisement
Table of Contents
