BOMBARDIER 1996 Ski-doo MX Z440 Handbook page 63

, A06FOWS
Maximum deflection 0.025 mm (.001 in)
After the new or replacement shim pack has been selected, reassemble in the reverse order of
disassembly. Torque piston nut 11-13 Nom (96-108 Ibfoin). Use 271 Loctite.
, A06FOXS
CAUTION: The damper rod nut can only be reused 4 times, then, must be replaced.
Do not substitute this part for non - O.E.M. use Loctite 271 on nut each time.
2. This spacer washer(s) P/N 414888309 must be used as shown to ensure damper rod nut does
not bottom out or contact shaft threads.
3. Rebound valve stopper with round edge facing shim stack.
4. NOTE : Rebound shim stack must not reach into threads of damper shaft. Washer
0
under damper shaft nut is used to prevent damper shaft nut from bottoming on threads.
Section 03 CHASSIS PREPARATION
03-47