BOMBARDIER 1996 Ski-doo MX Z440 Handbook page 49

1. 506115100 Stabilizer Bar
2. 506115200 Spacer (2)
3. 506108100 Lever (2)
4. 506115000 Spacer (2)
5. 222003565 Screw MIO x 1.5 x 35 (2)
6. 224701170 Lock Washer (2)
INSTALLATION PROCEDURE
Unfasten rear attachment of swing arms.
Remove existing stabilizer bar by drilling out rivets of plastic bushings on both side.
Ream plastic bushings to 19.05 mm (.750 in) inside diameter.
Reinstall plastic bushings with supplied rivets. Install new stabilizer bar, spacers and levers.
o
NOTE : Position of levers depends on snowmobile use.
Apply grease to both spacers linking swing arms.
Install snap rings.
, A06GOQS
SEEN FROM UNDERNEATH
1. Grease
Fasten rear attachment of swing arms.
Section 03 CHASSIS PREPARATION
7. 222085065 Screw M8 x 1.25
8. 224081201 Flat Washer M8 (4)
9. 228581045 Nut M8 (2)
10. 371900900 Snap Ring (2)
11. 390402300 Rivet (8)
50 (2)
x
03-33